Edge-Core ECS4110-28T Management Manual page 984

| Access Control Lists
C 26
HAPTER
MAC ACLs
permit, deny
(MAC ACL)
E
XAMPLE
Console(config)#access-list mac jerry
Console(config-mac-acl)#
R C
ELATED OMMANDS
permit, deny (984)
mac access-group (987)
show mac access-list (988)
This command adds a rule to a MAC ACL. The rule filters packets matching
a specified MAC source or destination address (i.e., physical layer address),
or Ethernet protocol type. Use the no form to remove a rule.
S
YNTAX
{permit | deny}
{any | host source | source address-bitmask}
{any | host destination | destination address-bitmask}
[vid vid vid-bitmask] [ethertype protocol [protocol-bitmask]]
{{ip {any | host source-ip | source-ip network-mask}
{any | host destination-ip | destination-ip network-mask}
{ipv6 {any | host source-ipv6 | source-ipv6/prefix-length}
{any | host destination-ipv6 | destination-ipv6/prefix-length}}
[protocol protocol]
[l4-source-port sport [port-bitmask]]
[l4-destination-port dport [port-bitmask]}]
[time-range time-range-name]
no {permit | deny}
{any | host source | source address-bitmask}
{any | host destination | destination address-bitmask}
[vid vid vid-bitmask] [ethertype protocol [protocol-bitmask]]
{{ip {any | host source-ip | source-ip network-mask}
{any | host destination-ip | destination-ip network-mask}
{ipv6 {any | host source-ipv6 | source-ipv6/prefix-length}
{any | host destination-ipv6 | destination-ipv6/prefix-length}}
[protocol protocol]
[l4-source-port sport [port-bitmask]]
[l4-destination-port dport [port-bitmask]}]
The default is for Ethernet II packets.
N :
OTE
– 984 –