Snmp-Server Enable Port-Traps Mac-Notification - Edge-Core ECS4110-28T Management Manual

◆
◆
E
XAMPLE
R
ELATED
snmp-server enable traps (798)
This command enables the device to send SNMP traps (i.e., SNMP
snmp-server
notifications) when a dynamic MAC address is added or removed. Use the
enable port-traps
no form to restore the default setting.
mac-notification
S
YNTAX
D
EFAULT
Disabled
C
OMMAND
Interface Configuration (Ethernet, Port Channel)
Specify the target host that will receive inform messages with the
5.
snmp-server host command as described in this section.
To send an inform to a SNMPv3 host, complete these steps:
Enable the SNMP agent
1.
Create a remote SNMPv3 user to use in the message exchange
2.
process (page 805).
Create a view with the required notification messages
3.
Create a group that includes the required notify view
4.
Allow the switch to send SNMP traps; i.e., notifications
5.
Specify the target host that will receive inform messages with the
6.
snmp-server host command as described in this section.
The switch can send SNMP Version 1, 2c or 3 notifications to a host IP
address, depending on the SNMP version that the management station
supports. If the snmp-server host command does not specify the
SNMP version, the default is to send SNMP version 1 notifications.
If you specify an SNMP Version 3 host, then the community string is
interpreted as an SNMP user name. The user name must first be
defined with the snmp-server user
group will be automatically created by the snmp-server host
command using the name of the specified community string, and
default settings for the read, write, and notify view.
Console(config)#snmp-server host 10.1.19.23 batman
Console(config)#
C
OMMANDS
[no] snmp-server enable port-traps mac-notification
mac-notification - Keyword to issue trap when a dynamic MAC
address is added or removed.
S
ETTING
M
ODE
– 801 –
C 22
HAPTER
SNMP Target Host Commands
(page 795).
command. Otherwise, an SNMPv3
| SNMP Commands
(page 806).
(page 804).
(page 798).