Texas Instruments TMS320C28x Reference Manual page 4

Notational Conventions
About This Manual / Notational Conventions
Chapter 7
Appendix A
Appendix B
Appendix C
Appendix D
Appendix E
Appendix F
Appendix G
Notational Conventions
This document uses the following conventions:
iv
Emulation Features
This chapter describes the TMS320C28x emulation features that can be
used with only a JTAG port and two additional emulation pins.
Register Quick Reference
This appendix is a concise central resource for information about the status
and control registers of the CPU. The chapter includes figures that summa-
rize the bit fields of the registers.
Submitting ROM Codes to TI
This appendix describes the procedures for getting code-customized ROM
in a Texas Instruments (TI) DSP.
C2xLP and C28x Architectural Differences
This appendix describes the differences in the architecture of the C2xLP and
the C28x.
Migration From C2xLP
This appendix explains how to migrate code from the C2xLP to the C28x.
C2xLP Instruction Set Compatibility
This appendix describes the instruction set compatibility with the C2xLP.
Migration From C27x to C28x
This appendix explains how to migrate code from the C27x to the C28x.
Glossary
This appendix explains abbreviations, acronyms, and special terminology
used throughout this document.
The device number TMS320C28x is very often abbreviated as '28x.
-
Program examples are shown in a special typeface. Here is a sam-
-
ple line of program code:
PUSH IER
Portions of an instruction syntax that are in bold should be entered as
-
shown; portions of a syntax that are in italics are variables indicating in-
formation that should be entered. Here is an example of an instruction
syntax:
MOV ARx, *−SP[6bit]
MOV is the instruction mnemonic. This instruction has two operands, indi-
cated by ARx and *−SP[6bit]. Where the variable x appears, you type a