Table of Contents
Advertisement
Safety Notices
INJURY HAZARD
WARNING
If the equipment is used in a manner not specified by Teledyne CETAC
Technologies, the protection provided the equipment may be impaired.
Repair or service that this not covered in this manual should only be
performed by qualified personnel.
The power cord set supplied with your instrument meets the requirements of
Power Cord Set Requirements
the country where you purchased the instrument. Power is supplied to the
autosampler through the included 24 V power supply.
The operator should check the power/signal supply cord condition. The
Power Cord Safety Maintenance
equipment should not be operated if the mains inlet is cracked or broken. Any
obvious damage to the case (from a drop or fall) should be checked by service
personnel for loose or damaged parts. See individual parts lists for approved
replacement parts.
The power switch on the rear panel is not the mains disconnect. Power mains
Mains Disconnect
disconnect is accomplished by unplugging the power cord at the power supply
or at the wall outlet. Ensure the power cord is easily accessible and removable,
in the event of an emergency which requires immediate disconnection.
SHOCK HAZARD
WARNING
Ensure that power cord is disconnected before removal of any covers.
ASX-112FR Autosamplers Operator's Manual
Chapter 9: Safety and Regulatory Information
79
Advertisement
Table of Contents
