Table of Contents
Advertisement
2.13.1 Set Default Tube
Volumes
2.13.2 User Preferences
Figure 2-17 User Preferences screen
EAR99 Technology Technology Subject to Restrictions Contained on the Cover Page
assumes any additional risk and has taken any additional steps
to mitigate the increased risk of disabling or lowering the Vapor
Limit sensitivity level.
Click this button to set the default volume of the collection tubes.
There is some variation in the fraction size as a function of flow
rate. Be sure you don't overflow the containers by setting the
default volume too close to the actual capacity.
The system will automatically advance to the next tube when
this default volume is met in each tube. Keep in mind that this
level can be set for each separation in the M
During the separation, other factors such as automatic tube
advances for detected peaks will affect collected volume.
View the U
P
SER
REFERENCES
for individual users. This is especially convenient if the system is
shared by several individuals with different preferences
(Figure 2-17).
Note
New systems will only have one user account named "com-
mon."
Language – Select the user's desired language from the
drop-down list box.
Automatically Print Report at End of Run – If the system is
on the network and a printer is configured, then this command
allows a report to be printed automatically. If you want to auto-
matically save the PDF to a network location, see Section 4
Network Configuration.
CombiFlash NextGen Systems
Section 2 Preparation
ETHOD
tab to configure system operation
E
.
DITOR
2-19
Advertisement
Table of Contents
