Table of Contents
Advertisement
Configuration
4.1 System
Result
The counters of the selected interfaces are displayed.
4.1.1.8
show interface mtu
Description
With this command, you show the setting for the Maximum Transmission Unit (MTU) of the
interfaces on the device.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
show interface mtu [{vlan<vlan-id(1-4094)>|
The parameters have the following meaning:
Parameter
vlan
vlan-id
interface-type
interface-id
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 29)".
If no parameters are specified, the settings for all interfaces are displayed.
Result
The settings are displayed.
4.1.1.9
show ip interface
Description
This command shows the configuration of one, several or all IP interfaces.
54
<interface-type><interface-id>}]
Description
Keyword for a VLAN connection
Number of the addressed VLAN
Type or speed of the interface
Module no. and port no. of the interface
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Range of values / note
-
1 ... 4094
Enter a valid interface.
Configuration Manual, 09/2017, C79000-G8976-C324-08
Hide quick links:
Advertisement
Table of Contents
