Enabling Static Lacp Configuration - Siemens SCALANCE W1750D UI Configuration Manual

Wired Profiles
12.5 Link Aggregation Control Protocol
12.5.2

Enabling Static LACP Configuration

When APs connect to switches which have the LACP capability, the LACP feature does not
work as expected. To enable a static LACP configuration, new commands are introduced.
APs support the dynamic LACP configuration according to a peer switch. When the peer
switch enables LACP configuration, the APs form the LACP. Users can enable, disable, and
remove the static LACP configuration in the AP. When the AP boots up, it forms the LACP
according to the static configuration.
To enable the static LACP mode on APs:
(scalance)# lacp-mode enable
To disable the static LACP mode on APs:
(scalance)# lacp-mode disable
Verifying Static LACP Mode
To verify the static LACP configuration, execute the following command in the AP CLI:
(scalance)# show ap-env Antenna
Type:Internal
name:TechPubsAP
per_ap_ssid:1234
per_ap_vlan:abc
lacp_mode:enable
158
Configuration Manual, 02/2018, C79000-G8976-C451-02
SCALANCE W1750D UI