Table of Contents
Advertisement
Chapter 2
Installing the Device
12. Trim away any excess foil or drain wire extruding from the strain relief.
13. Slide the connector components up to the plug body.
14. Insert the modular plug into the plug housing.
Figure 14: Assembling the Connector Components
1. PoE Plug
2. Plug Housing
15. Align the latch with the LATCH slot.
16. Press the plug into the plug housing until it bottoms out.
17. While maintaining inward pressure on the plug or keeping the dust cover engaged, tighten the compression
nut to 0.56 N·m (5 In-lbs).
Figure 15: Connecting the PoE Cable to the CPE
1. PoE Cable
2. Dust Cover
Section 2.4
Connecting the WIN1010 Data Adapter (AC Only)
The RUGGEDCOM WIN1010 data adapter powers the device and distributes data. The WIN1010 data adapter
unit provides RJ45 input connectors that include 10/100Base-T transceivers for connection to an IEEE802.3
(10/100Base-T) compatible device. The unit receives power from 100 to 240VAC using an IEC-320-C14 industry
standard connector.
CAUTION!
The power supply AC cord should be 3 wires, 18 AWG minimum, with length less than 4.5 m (14.8 ft),
and safety certified according to national rules.
16
3. Dust Cover
2
1
3. Plug Housing
4. CPE
1
2
3
3
4
Connecting the WIN1010 Data Adapter (AC Only)
RUGGEDCOM WIN5137
Installation Guide
Advertisement
Table of Contents
