Table of Contents
Advertisement
Syntax
Call up the command with the following parameters:
ntp server { ipv4 <ip_addr> | fqdn-name <Fully Qualified Domain
Name(100)> | ipv6 <ip6_addr> } [port { <1025-36564> | default}] [poll
<seconds(64-1024)>]
The parameters have the following meaning:
Parameter
id
ipv4
ip_addr
fqdn-name
FQDN
ipv6
ip6_addr
port
default
poll
seconds
For information on identifiers of addresses and interfaces, refer to the section "Addresses and
interface identifiers (Page 29)".
Result
The connection to a server is configured on the NTP client.
Further notes
You delete the connection to a server with the no ntp server command.
You store a domain name with the ip domain name or domain name command.
6.2.3.2
no ntp server
Description
With this command, you delete the connection to a server on the NTP client.
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08
Description
Number of the NTP server.
Keyword for an IPv4 address
Value for the IPv4 address of the time
server
Keyword for a domain name
Domain name (Fully Qualified Domain
Name)
Keyword for an IPv6 address
Value for the IPv6 address of the time
server
UDP port of the time server
Default value for the UDP port
Keyword for the time after which the
time of day is requested again
Value for the time in seconds
System time
6.2 NTP client
Range of values / note
1 ... 4
-
Enter a valid IPv4 address.
-
Maximum of 100 characters
If you have stored a suitable do‐
main name, you can specify a host
name.
-
Enter a valid IPv6 address.
1025 ... 36564
123
-
64 ... 1024
175
Hide quick links:
Advertisement
Table of Contents
