Hydraulic Reservoir Tank - Toro Dingo TX 413 Service Manual

MAINTENANCE
6. Place the greased road wheel cap and seal over
the bolt head.
7. Secure the road wheel cap with the snap ring
(Fig. 008).
Figure 008
Note: It is not always necessary to remove
the track guide when replacing any of
the road wheel bearings. They can also
be removed by raising the unit off the
ground. For safety reasons, make sure the
frame of the unit is supported.
3-4

Hydraulic Reservoir Tank

Location
The hydraulic reservoir tank is located in the front of
the TX 413 unit.
Hydraulic Tank Capacity: 10 gallons (37.85 liters)
Type of Oil to Use: 10W-30 detergent, diesel
engine oil (API service CH-4 or higher)
Checking the Hydraulic Fluid
Check the hydraulic fluid level before the engine is
first started and after every 25 operating hours.
1. Remove the attachment, if one is installed.
2. Park the traction unit on a level surface, lower the
loader arm, and fully retract the tilt cylinder.
3. Stop the engine, remove the key, and and allow
the engine to cool.
DSC-0821
4. Clean the area around the filler neck of the
hydraulic tank (Fig. 009).
Rev. 000
Figure 009 DSC-0771
TX 413 Service Manual