DRIVE SYSTEM
Wheel Motor Removal
Note: This procedure can be used for the Left
or Right Wheel Motor
1. Lift and securely support the unit so that the track
is far enough off the ground to remove the wheel
motor.
2. Remove rear cover.
3. Disconnect the negative battery cable and then
the positive cable; remove the battery. Slide an oil
drain pan under the wheel motor (Fig. 474).
Figure 474
8-16
4. Remove the track; refer to the Track Removal
section, page 8-4.
5. Remove cotter key from the motor shaft (Fig.
475).
6. Remove castle nut on the motor shaft (Fig. 476).
Note: A self-locking nut with thread-locking
material may be used. This self-locking
nut needs to be replaced whenever it is
removed from the wheel motor shaft.
DSC-0856
Rev. 000
Figure 475
DSC-0837
Figure 476
DSC-0838
TX 413 Service Manual