Toro Dingo TX 413 Service Manual page 152

4. Install the spool spring with a hex head screw,
torque to 5 ft-lbs. (6.8 Nm) (Fig. 415).
Note: Lubricate the spring with synthetic base
grease grade NLGI2.
Figure 415
5. Install the spring cap and torque the hex head
screws to 5 ft-lbs. (6.8 Nm) (Fig. 416).
Figure 416
TX 413 Service Manual
6. Lubricate the cavity of the top lever assembly
with a synthetic base grease grade NLGI2. Install
the lever assembly and gasket. Torque the hex
head screws to 5 ft-lbs. (6.8 Nm) (Fig. 417).
DSC-1457
DSC-1458
Rev. 000
HYDRAULIC LIFT ASSEMBLY
Figure 417 DSC-1460
7-63