Reassemble Power Head Into Frame Assembly - Toro Dingo TX 413 Service Manual

ATTACHMENTS
4. While supporting the auger housing, remove the
pivot plate on one side from the frame assembly.
The auger housing can now be set aside (Fig. 038).
5. Now remove the three pivot plate bolts from the
other side and remove the pivot plate (Fig. 039).
B
A
A. Nuts and bolts
B. RH pivot plate
10-12
Fig 038 PICT-8710
D
C
Fig 039 CLR DSC-0174
C. Auger housing
D. LH pivot plate
6. Remove the stop pad from the frame assembly (Fig.
040).
Reassemble Power Head into Frame
Assembly
1. Install the stop pad on the frame assembly (Fig.
041).
A
Rev. 001
Fig 040 CLR DSC-0155
Fig 041
CLR DSC-0155
TX 413 Service Manual