Disassembly; Assembly - Toro Dingo TX 413 Service Manual

HYDRAULIC LIFT ASSEMBLY
Auxiliary Valve Disassembly and

Assembly

Before disassembly of any hydraulic component, use
a clean, dirt-free work surface and clean solvent to
prevent system contamination (Fig. 403).
A
B
C
D
Figure 403
A. Operator lever
B. Inlet
C. Detent
D. Return spring cap

Disassembly

1. Remove the top lever assembly by removing the
two hex head screws (Fig. 404).
Figure 404
7-60
E
B
F
G
DSC-1443
E. Rubber bellows
F. Return
G. Safety switch port
DSC-1444
2. Remove the spring cap by removing the two hex
head cap screws (Fig. 405).
3. Remove the spool spring by removing the hex
cap screw. Use a drift punch to hold the top of
the spool (Fig. 406).
Rev. 000
Figure 405 DSC-1445
Figure 406 DSC-1446
TX 413 Service Manual