Track Guide Alignment - Toro Dingo TX 413 Service Manual

DRIVE SYSTEM
4. Install compression spring and the bolt tensioner
with tensioning nut.
Note: Make sure the tensioning nut is contacting
the bolt tensioner (Fig. 442).
A
B
C
Figure 442
A. Tensioning nut
B. Compression spring
5. Install the tensioner assembly into the frame (Fig.
443).
Figure 443
8-8
D
DSC-0815
C. Tensioning bolt
D. Tension Arm
DSC-1724

Track Guide Alignment

Alignment Tool – P/N 110-0069 (Fig. 444)
1. Insert the notched end of the alignment tool into
the drive wheel spacer (Fig. 445).
Rev. 000
Figure 444 DSC-0624
Figure 445 DSC-0625
TX 413 Service Manual