Toro Dingo TX 413 Service Manual page 130

Note: If excessive wear due to side-loads or
binding is a possibility, mark or note the
piston and head relationship to the rod
and tube. This condition will usually show
up as a highly polished surface on the
piston and head 90° to the pin rotation axis
(Fig. 333).
Figure 333
3. Using a spanner wrench, install in the holes
provided. Rotate the head clockwise until
the edge of the retaining ring appears in the
milled opening of the tube. Insert a flat blade
screwdriver between the beveled edge of the
retaining ring and the cylinder barrel to start the
retaining ring through the opening.
TX 413 Service Manual
4. Rotate counter-clockwise until the retaining ring is
completely removed (Fig. 334).
5. Pull out on the rod to remove the piston and head
assembly from barrel (Fig. 335).
DSC-1329
Rev. 000
HYDRAULIC LIFT ASSEMBLY
Figure 334
Figure 335
DSC-1335
DSC-1338
7-41