Hydrostatic Pump (Right Drive) Hydraulic Fitting Orientation; Hydrostatic Pump (Left Drive) Hydraulic Fitting Orientation; Hydrostatic Pump Lever Assembly Removal And Installation - Toro Dingo TX 413 Service Manual

11. Install drive belt; refer to Drive Belt Installation
section on page 8-3.
12. Install battery and battery cables.
13. Follow the Purging Air Procedures; refer to the
Purging Air Procedures section on page 6-4.
14. Check all the hydraulic line connections for any
leaks.
15. Check the traction control for neutral; refer to
Traction Control Neutral Position section on page
6-5.
16. Check the traction unit for tracking. If adjustment
is needed, refer to the Adjusting the Tracking
of the Traction Control, Full Forward Position
section on page 6-4.
17. Install the drive belt cover and rear cover. Lower
the traction unit to the ground. Operate the unit to
make sure everything is operating properly.
Hydrostatic Pump (Right Drive) Hydraulic
Fitting Orientation
A. Linkage Bracket
B. Wheel Motor
C. Case Drain
E
D
Figure 144
TX 413 Service Manual
D. Inlet
E. Bypass
A
B
C
DSC-0880
Rev. 000
HYDRAULIC SYSTEM
Hydrostatic Pump (Left Drive) Hydraulic
Fitting Orientation
A. Case Drain
B. Inlet
C. Bypass
E
D
Figure 145
Hydrostatic Pump Lever Assembly
Removal and Installation
1. Remove the two retention bolts and nuts holding
the pump lever assembly and the traction clamp
to the trunnion arm of the hydrostatic pump (Fig.
146).
Figure 146
D. Linkage Bracket
E. Wheel Motor
A
B
C
DSC-0899
DSC-0881
6-17