Hydraulic Tilt Cylinder Installation - Toro Dingo TX 413 Service Manual

HYDRAULIC LIFT ASSEMBLY
12. Remove the bolt and nut on the pivot pin located
on the barrel end of the hydraulic tilt cylinder (Fig.
239).
Figure 239
13. Using a drift punch and hammer, drive the pivot
pin out of the barrel end of the hydraulic tilt
cylinder and remove the cylinder (Fig. 240).
Figure 240
7-16
14. Remove the hydraulic hoses from the tilt cylinder
(Fig. 241).
DSC-0983
15. For information on repairing the Tilt Hydraulic
Cylinder, refer to the Hydraulic Cylinder Service
section of this manual, page 7-40.

Hydraulic Tilt Cylinder Installation

Note: As a reminder, prior to connecting the
hydraulic lines, the O-rings and seals
should be replaced with new ones and
lightly lubricated with petroleum jelly.
DSC-0985
Rev. 000
Figure 241 DSC-0986
TX 413 Service Manual