Traction Control Handle Assembly Removal - Toro Dingo TX 413 Service Manual

DRIVE SYSTEM
Note: Self-locking nut with thread-locking
material may be used with some model
years. This self-locking nut needs to be
replaced whenever it is removed from the
wheel motor shaft (Fig. 488).
Figure 488
7. Install track; refer the Track Installation, page 8-8.
8. Reinstall battery and battery cables; connect
positive cable first.
9. Purge the unit of any air that may be trapped
in the hydraulic system; refer to Purging Air
Procedures, page 6-4. Check for any oil leaks.
10. Lower the unit to the ground and reinstall the rear
cover and belt cover.
8-20
Traction Control Handle Assembly
Removal
1. Remove the rear cover.
2. Remove the bolt and nut retaining the control
handle assembly to the drive rod assembly (Fig.
489).
DSC-0852
3. Mark or tag the right side linkage rod and remove
the bolt, spacer, and nut in the rod end bearing
(Fig. 490).
Rev. 000
Figure 489 DSC-1247
Figure 490 DSC-1264
TX 413 Service Manual