4. Remove the bolt and nut retaining the pivot pin
on the ram end of the lift cylinder (Fig. 288).
Figure 288
5. Remove the cylinder lock and lower lift arm.
Support the loader arm assembly with an
overhead lift (Fig. 289).
Figure 289
TX 413 Service Manual
Note: Units with serial numbers from 240000100
through 240000200 have a fixed fitting
(Fig. 290).
DSC-1043
Note: Units with serial numbers from 240000201
and higher have a swivel fitting (Fig. 291).
DSC-1069
Rev. 000
HYDRAULIC LIFT ASSEMBLY
Figure 290
Figure 291
DSC-1029
DSC-1030
7-29