Toro Dingo TX 413 Service Manual page 176

4. Install the left side rod linkage with a bolt through
the bearing rod end, spacer, through the drive
rod assembly and install the nut and tighten (Fig.
499).
Figure 499
5. Install the right side rod linkage with a bolt
through the bearing rod end, spacer, through the
drive rod assembly and install the nut and tighten
(Fig. 500).
Figure 500
TX 413 Service Manual
6. Insert the bolt and nut into the traction control
handle assembly and through the drive rod
assembly.
Note: The control handle assembly is slotted,
so you need to align the assembly before
tightening the bolt and nut (Fig. 501).
DSC-1263
7. Install the rear cover.
DSC-1264
Rev. 000
DRIVE SYSTEM
Figure 501 DSC-1247
8-23