6. Using a drift punch and hammer, tap out the seal
(Fig. 462).
Figure 462
Installation of Road Wheel Bearing and
Road Wheel Assembly
1. The raised portion of the bearing should be
installed toward the seal side (Fig. 463).
Figure 463
TX 413 Service Manual
2. Pressing on the outer race, press bearing in until
it seats against the inner shoulder of the road
wheel (Fig. 464).
DSC-0828
3. Apply grease around the bearing before installing
the seal (Fig. 465).
DSC-0829
Rev. 000
DRIVE SYSTEM
Figure 464
DSC-0830
Figure 465
DSC-0831
8-13