Loader Arm Assembly Installation - Toro Dingo TX 413 Service Manual

Loader Arm Assembly Installation

1. Route the tilt cylinder hoses through the opening
of the frame (Fig. 304).
Note: Make sure the hoses are routed to the
inside of the auxiliary hoses that go to the
quick coupler.
Figure 304
2. Lower the loader arm down into the frame. Apply
a thin layer of grease to the pivot pin and push
the pivot pin through the loader arm assembly
(Fig. 305).
Figure 305
TX 413 Service Manual
3. Use a drift punch in the first hole to align the hole
for the bolt. Install bolt and nut and tighten to 16
+ 2 ft-lbs. (21.7 + 2.7 Nm) (Figure 306).
4. Install the two vent hoses, located above the oil
DSC-1061
filter bracket. The top vent is for the fuel tank
(A) and the bottom vent is for the hydraulic
reservoir (B) (Fig. 307).
Note: Prior to connecting the hydraulic lines,
the o-rings and seals should be replaced
with new ones and lightly lubricated with
DSC-1062
petroleum jelly.
Rev. 000
HYDRAULIC LIFT ASSEMBLY
Figure 306
Figure 307
DSC-1063
A A
B B
DSC-1064
7-33