Toro Dingo TX 413 Service Manual page 76

4. Disconnect and remove the hydraulic line going
to the loader arm valve (Fig. 150).
Figure 150
5. Loosen the hose clamp and remove the hydraulic
suction hose from the front of the gear pump and
slide the hose off the fitting (Fig. 151).
Figure 151
TX 413 Service Manual
6. Loosen and remove the two mounting bolts and
nuts that retain the gear pump to the frame.
Once the pump mounting bolts are loosened and
removed, the pump can be pulled away from the
frame and the pulley can be removed from the
shaft (Fig. 152).
DSC-0911
7. Remove the gear pump from the frame (Fig.
153).
DSC-0912
8. For information on repairing the gear pump refer
to the Gear Pump Repair section on page 6-21.
Rev. 000
HYDRAULIC SYSTEM
Figure 152 DSC-0913
Figure 153 DSC-0916
6-19