Engine Installation - Toro Dingo TX 413 Service Manual

ENGINE
27. With an overhead hoist, raise the engine slightly
and slide the engine forward and then up and off
the frame of the unit (Fig. 041).
Figure 041

Engine Installation

1. Lower engine to the frame (Fig. 042).
Figure 042
4-8
2. Install the two rear engine mounting bolts and
nuts.
Note: Make sure the two ground wires are
installed on the left rear bolt, with the star
washer installed first. DO NOT TIGHTEN
THE BOLTS AND NUTS. (Fig. 043)
DSC-1118
3. Install the two front engine mounting bolts and
nuts.
Note: DO NOT TIGHTEN THE BOLTS AND NUTS
(Fig. 044).
DSC-1118
Rev. 000
Figure 043 DSC-1115
Figure 044 DSC-1120
TX 413 Service Manual