Greasing The Traction Unit - Toro Dingo TX 413 Service Manual

MAINTENANCE

Greasing the Traction Unit

Grease all pivot joints every 8 operating hours and
immediately after every washing.
Grease Type: Lithium based NLGI2
1. Lower the loader arm and stop the engine.
Remove the key from the ignition switch.
2. Clean the grease fittings with a rag.
3. Connect grease gun to each fitting and pump
grease into the fittings until grease begins to ooze
out of the bearings (approximately 3 pumps).
4. Wipe any excess grease.
There are 11 grease fittings on the TX413: (3) are
located on the left side (Fig. 001).
Figure 001
3-2
(1) is located under the hood for the loader arm
assembly (Fig. 002).
(5) are located in the front on the quick attachment
assembly and the front loader arm assembly (Fig.
003).
DSC-0764
Rev. 000
Figure 002 DSC-0766
Figure 003 DSC-0767
TX 413 Service Manual