Toro Dingo TX 413 Service Manual page 100

6. Connect the neutral ball switch at the harness
connector (Fig. 220).
Figure 220
7. Slide the torsion spring over the control shaft,
with the large hook end of the spring facing down
(Fig. 221).
Figure 221
TX 413 Service Manual
8. Turn the torsion spring clockwise and hold. Slide
the auxiliary lever over the control shaft and hook
the spring end over the auxiliary lever (Fig. 222).
DSC-0942
9. Install the washer and retention nut on the top of
the lever and tighten the nut (Fig. 223).
DSC-0954
10. Start the unit and check the hydraulic fittings for
any leaks. Install a hydraulic attachment and
operate the auxiliary valve in both the forward
and reverse flow to purge any air out of the
system. Also, operate the loader arm valve up,
down, and tilt to help purge the system of any air.
Recheck for leaks.
11. Install the rear cover.
Rev. 000
HYDRAULIC LIFT ASSEMBLY
Figure 222
Figure 223
DSC-0941
DSC-0939
7-11