Track Guide Removal; Road Wheel Bearing Replacement - Toro Dingo TX 413 Service Manual

Track Guide Removal

1. Raise and securely support the side of the unit
to be worked on so that the track guide is far
enough off the ground to remove from the unit.
2. Remove the track, refer to "Track Removal" on
page 8-4.
3. Install a hydraulic floor jack and 6" (15.24cm)
wide board long enough to fit under the track
guide (Fig. 454).
Figure 454
4. Remove the four bolts holding the track guide to
the frame (Figure 455).
Figure 455
TX 413 Service Manual
5. Lower the track guide from the frame (Fig. 456).

Road Wheel Bearing Replacement

Check and grease the road wheels every 250
operating hours, or yearly.
Note: It is usually not necessary to remove
the track guide when replacing any of
DSC-0817
the road wheel bearings. They can also
be removed by raising the unit off the
ground. For safety reasons, make sure the
frame of the unit is securely supported.
1. Remove the snap ring from the inner hub of the
road wheel (Fig. 457).
DSC-0819
Rev. 000
DRIVE SYSTEM
Figure 456 DSC-0820
Figure 457 DSC-0821
8-11