Toro Dingo TX 413 Service Manual page 215

ATTACHMENTS
6. Remove any dirt or debris from the auger shaft and
slide it into the auger housing (Fig. 054).
7. Remove the 1/2" x 2-3/4" bolt securing the auger
housing. Rotate the shaft down and lower arm.
Insert the new bearing lockwasher onto the auger
shaft. Make sure the tangs are facing out towards
the bearing nut (Fig. 055).
10-16
Fig 054 CLR DSC-0161
Fig 055 CLR DSC-0163
8. Align the inner tab of the lock washer with the slot on
the auger shaft (Fig. 056).
9. With the auger shaft pointing down on a secure
surface, place a 7/8" round stock through the shaft to
prevent it from turning when torquing the bearing nut
(Fig. 057).
Rev. 001
Fig 056 CLR DSC-0165
Fig 057 CLR DSC-0179
TX 413 Service Manual