Bulkhead Fuel Fitting Replacement - Toro Dingo TX 413 Service Manual

ENGINE

Bulkhead Fuel Fitting Replacement

1. Remove the nut and washer from the fuel fitting
(Fig. 072).
Figure 072
2. Tape a piece of steel wire approximately 30" long
to the fitting , then push the fitting into the tank,
tilt the tank and feed the fuel fitting out the fill
neck of the fuel tank (Fig. 073).
Figure 073
4-16
3. Remove the fuel fitting from the steel wire. Tape a
new fuel fitting to the steel wire and pull the fitting
through the fuel tank and out the bottom of the
tank (Fig. 074).
DSC-1140
4. Remove the wire and install the washer and nut
on the fitting, then finger tighten the nut. Orient
the fitting as shown (Fig. 075).
DSC-1141
Rev. 000
Figure 074 DSC-1142
Figure 075 DSC-1143
TX 413 Service Manual