HYDRAULIC LIFT ASSEMBLY
3. Tap the pivot pin out of the ram end of the tilt
cylinder using a hammer and drift punch (Fig.
323).
Figure 323
4. Support the tilt cylinder and remove the pivot pin
(Fig. 324).
Figure 324
7-38
5. Remove the right and left shoulder bolt retaining
the pivot pins located on both sides of the quick
attachment assembly. Remove both pivot pins
(Fig. 325).
DSC-1079
6. Slide the quick attachment assembly away from
the loader arms (Fig. 326).
DSC-1080
Rev. 000
Figure 325
DSC-1081
Figure 326
DSC-1083
TX 413 Service Manual