2. Secure the end with the pin (Fig. 446).
Figure 446
3. Rotate the tool and move the track guide as
necessary until the tool fi ts into the track guide
channel. Secure the end of the tool with a strap
(Fig. 447).
Figure 447
TX 413 Service Manual
4. Tighten and torque the 4 track guide mounting
bolts to 75 ft lbs (102 Nm) (Fig. 448).
DSC-0628
5. Remove the alignment tool.
Track Installation
1. Engage the lugs on the track between the
spacers on the drive sprocket (Fig. 449).
DSC-0629
Rev. 000
DRIVE SYSTEM
Figure 448
DSC-0631
Figure 449
DSC-0801
8-9