18. Install the hydraulic hoses to the hydraulic motor
Note: Replace the o-ring seals on the hydraulic
fittings (Fig. 066).
19. Stabilize the auger head by sliding the 1/2" x 2-3/4"
bolt into cradle arm (Fig. 067).
TX 413 Service Manual
Fig 066
CLR DSC-0203
Fig 067
CLR DSC-0144
ATTACHMENTS
20. Torque the hydraulic fittings to 42 + 5 ft-lbs. (56.9 +
6.8 Nm) (Fig. 068).
21. Install the other end of the hydraulic hoses onto the
flush face couplers (Fig. 069).
Rev. 001
Fig 068
CLR DSC-0206
Fig 069
CLR DSC-0204
10-19