4. Disconnect the left side linkage rod by removing
the bolt, spacer, and nut from the rod end bearing
(Fig. 491).
Figure 491
5. Remove four bolts and nuts that retain the
bushings, located on each side of the control
support assembly (Fig. 492).
Figure 492
TX 413 Service Manual
6. Turn the traction control assembly clockwise and
remove the bushings, flat washers, and spring
washers from the control support assembly (Fig.
493).
DSC-1263
7. Turn the traction control assembly counter-
clockwise and maneuver the assembly until it
clears the neutral return bracket (Fig. 494).
DSC-1252
Rev. 000
DRIVE SYSTEM
Figure 493
DSC-1253
Figure 494
DSC-1254
8-21