Toro Dingo TX 413 Service Manual page 141

HYDRAULIC LIFT ASSEMBLY
6. Remove two hex head retaining screws that
retain the joystick base plate (Fig. 372).
Figure 372
7. Turn the valve assembly over. Remove the two
hex head retaining screws securing each spring
cap and remove (Fig. 373).
Figure 373
7-52
8. Using a drift punch to hold the top end of the
spool, remove the detent spring assembly from
the bottom of the spool (Fig. 374).
DSC-1399
9. Using a drift punch to hold the top end of the
spool, remove the spring valve assembly with a
hex wrench (Fig. 375).
DSC-1400
Rev. 000
Figure 374 DSC-1404
Figure 375 DSC-1406
TX 413 Service Manual