Toro Dingo TX 413 Service Manual page 216

10. Install the bearing nut onto shaft with the chamfer
side of the nut facing down towards the bearing
lockwasher (Fig. 058).
11. Torque the bearing nut to 150 ft-lbs. (203.37 Nm)
(Fig. 059).
TX 413 Service Manual
Fig 058
CLR DSC-0166
Fig 059 CLR DSC-0171
ATTACHMENTS
12. Once the torque value has been reached, if the
lockwasher tangs do not line up with the notches on
the bearing nut, continue to tighten the bearing nut
until two tangs from the bearing lockwasher line up
with the notches in the bearing nut (Fig. 060).
13. Bend the tabs from the bearing lockwasher into the
notches of the bearing nut (Fig. 061).
Rev. 001
Fig 060 CLR DSC-0185
Fig 061 CLR DSC-0189
10-17