Idler Assembly Removal - Toro Dingo TX 413 Service Manual

8. Brake Adjustment - Ensure the brake engages
and disengages freely. The brake bars should
both move in and out of the frame. When
disengaged, the brake bar should not protrude
more than 1/2" (12.7mm) out of the frame (Fig.
522).
Figure 522
If adjustment is needed, there are two jam nuts
located on the brake cable, next to the cable
bracket on the left inside of the frame (Fig. 523).
Loosen the jam nuts to adjust the brake bars.
Figure 523
9. Install the battery bracket. Install the battery
and the positive battery cable, then the negative
cable. Install the rear cover.
TX 413 Service Manual

Idler Assembly Removal

1. Raise engine cover and remove the belt cover.
2. Use a pry bar to relieve idler tension and remove
the drive belt (Fig. 524).
DSC-1292
3. Loosen the set screws on the engine drive pulley
and remove the pulley (Fig. 525).
DSC-1291
Rev. 000
DRIVE SYSTEM
Figure 524 DSC-1293
Figure 525 DSC-1294
8-29