Table of Contents
Advertisement
from the fuel line coming from the fuel tank and
toward the line going to the fuel pump.
Important:
Never install a dirty filter.
10.
Move the hose clamps close to the filter.
11.
Remove the clamp blocking fuel flow and open
the fuel valves.
12.
Secure the tank cap.
13.
Replace the side screen and close the hood.
Draining the Fuel Tank
1.
Park the machine on a level surface, engage the
parking brake, and lower the loader arms.
2.
Shut off the engine and remove the key.
3.
Syphon the fuel from the tank using a pump-type
syphon.
Note:
Now is the best time to install a new fuel filter
because the fuel tank is empty.
Electrical System
Maintenance
Electrical System Safety
•
Disconnect the cable from the negative terminal of
the battery before repairing the machine.
•
Charge the battery in an open, well-ventilated
area, away from sparks and flames. Unplug the
charger before connecting or disconnecting the
battery. Wear protective clothing and use insulated
tools.
•
Battery acid is poisonous and can cause burns.
Avoid contact with skin, eyes, and clothing. Protect
your face, eyes, and clothing when working with a
battery.
•
Battery gases can explode. Keep cigarettes,
sparks, and flames away from the battery.
Servicing the Battery
Always keep the battery clean and fully charged. Use
a paper towel to clean the battery case. If the battery
terminals are corroded, clean them with a solution of
4 parts water and 1 part baking soda. Apply a light
coating of grease to the battery terminals to reduce
corrosion.
Specifications: 12 V, 585 A (cold cranking)
Removing the Battery
WARNING
Battery terminals or metal tools could short
against metal machine components, causing
sparks. Sparks can cause the battery gasses
to explode, resulting in personal injury.
• When removing or installing the battery,
do not allow the battery terminals to touch
any metal parts of the machine.
• Do not allow metal tools to short between
the battery terminals and metal parts of the
machine.
1.
Park the machine on a level surface, engage
the parking brake (if equipped), and lower the
loader arms.
2.
Shut off the engine and remove the key.
3.
Open the hood.
4.
Remove the wing nuts and bar securing the
battery
(Figure
35
45).
Advertisement
Table of Contents
