Track Removal - Toro Dingo TX 413 Service Manual

DRIVE SYSTEM
3. Check belt routing, (Fig. 426). Start unit to make
sure the belt is operating properly.
Figure 426
4. Install drive belt cover with retaining knob, the
pulley cover with two bolts, and the rear cover.

Track Removal

1. Raise and securely support the side of the unit to
be worked on so that the track is 3 to 4" (7.6 to
10cm.) off the ground (Fig. 427).
Figure 427
8-4
2. Remove the bolt and nut securing the tensioner
bolt (Fig. 428).
106-9514 decal
3. Using a 1/2" drive socket ratchet, release the
drive tension by turning the tensioner bolt
clockwise until the tensioning nut contacts the
tensioner bolt head. Push the tension wheel
toward the rear of the unit (Fig. 429 and Fig 430).
DSC-0791
Rev. 000
Figure 428 DSC-0793
Figure 429 DSC-0794
Figure 430 track install #3
TX 413 Service Manual