General Specifications; Dimensions - Toro Dingo TX 413 Service Manual

SPECIFICATIONS
Special Tools
• Hydraulic Flow & Pressure Tester (Hydro-Gear BDP) Bi-directional Flow Test Kit (P/N 70661) or
equivalent
• 15º/60º Offset Open End Wrench, 1/8" and 15/16"
• Torque Wrenches - nominal torque ranges, plus one capable of 300 ft-lbs. (407 Nm)
• Multimeter

General Specifications

Item Specification
Engine Honda Model GX390 13 horsepower, 4-cycle, air cooled, single cylinder, overhead
valves, 12 VDC solenoid shift starter, 10 amp alternator, and low oil shut down.
RPM Setting No-load Speed - 3600 rpm + 150 rpm
Low Idle Speed - 1450 rpm + 150 rpm
Spark Plug NGK BPR6ES, Denso W20EPR-U or equivalent. Air Gap: 0.030 inch (0.76mm).
Oil Capacity 1.16 Quarts (1.1 liter)
Fuel Tank 3 Gallons (11.4 liter)
Fuel shut off Frame mounted electric fuel shut off

Dimensions:

Item
Overall Length (without Bucket)
Overall Length (with Bucket)
Overall Width (without Bucket)
Overall Width (with Bucket)
Overall Machine Height (Bucket
Lowered)
Overall Operating Height (Fully
Raised Bucket)
Wheel Base
Ground Clearance (Maximum)
Ground Clearance (Minimum)
Dump Angle
Bucket Roll Back (Ground Position)
Bucket Roll Back (Carry Position)
2-2
Specification
66.1" (167cm)
86.7" (220cm)
33.7" (85.6cm)
34.5" (87.6cm)
42.5" (107.9cm)
76.4" (194cm)
31.1" (78.9cm)
6.1" (15.5cm)
3.8" (9.7cm)
45°
25.2°
25.2°
Rev. 000 TX 413 Service Manual