Toro Dingo TX 413 Service Manual page 230

7. Line up the tab on the tongued washer with the
trencher shaft keyway and install (Fig. 112).
8. Line up the inner tab of the bearing lockwasher with
the trencher shaft keyway and install (Fig. 113).
Note: The angle of the bearing lockwasher tabs
should face up.
TX 413 Service Manual
Fig 112
CLR DSC-0347
Fig 113 CLR DSC-0348
ATTACHMENTS
9. Use a large slotted screwdriver to prevent the
trencher shaft from spinning and install the bearing
locknut. Torque to 45 ft-lbs. (61 Nm) (Fig. 114).
10. After the proper torque value has been reached, line
up two of the lockwasher tangs and bend into the
slots on the locknut (Fig. 115).
Rev. 001
Fig 114 CLR DSC-0351
Fig 115 DSC-352
10-31