Toro Dingo TX 413 Service Manual page 137

HYDRAULIC LIFT ASSEMBLY
3. Pictured below (Fig. 356) are the joystick joints:
A. Tilt Cylinder operation
B. Loader Lift Cylinder operation
C. Pivot for Lift and Tilt operation
A
Figure 356
4. Slide the end rod off the joystick pin of the
joystick joint for the Tilt Cylinder (Fig. 357).
Figure 357
7-48
5. Remove the pivot for the lift and tilt operation.
Remove the nut holding the joystick joint (Fig.
358).
B
C
DSC-1391
6. Turn the loader lift joystick joint and remove two
hex head screws, then remove the joystick pivot
(Fig. 359).
DSC-1726
Rev. 000
Figure 358 DSC-1395
Figure 359 DSC-1728
TX 413 Service Manual