Toro Dingo TX 413 Service Manual page 116

7. Connect the next hydraulic hose to the hydraulic
fitting on the lift valve and tighten (Fig. 281).
Figure 281
8. Units, with serial numbers 240000100 through
240000200 will have a clamp and hoses routed
as shown in Fig. 282.
Figure 282
TX 413 Service Manual
Units, with serial numbers 240000201 and higher
will have a clamp and hoses routed as shown in
Fig. 283.
DSC-1025
Proper hose placement through the clamp (Fig.
284).
A. Auxiliary Hose (female coupler)
B. Auxiliary Hose (male coupler)
C. Lift Cylinder Hose (ram end)
D. Tilt Cylinder Hose (ram end)
E. Tilt Cylinder Hose (barrel end)
F. Lift Cylinder Hose (barrel end)
B
Rear
DSC-1072
C
Rev. 000
HYDRAULIC LIFT ASSEMBLY
Figure 283
A
Figure 284
DSC-1073
D
E
Front
F
105-9000 clamp
7-27