Drive Belt Removal - Toro Dingo TX 413 Service Manual

DRIVE SYSTEM

Drive Belt Removal

1. Shut engine "OFF", apply parking brake, and
remove ignition key.
2. Remove belt cover knob and remove the belt
cover (Fig. 418).
Figure 418
3. Disconnect the two rear latches and remove the
rear cover (Fig. 419).
Figure 419
8-2
4. Remove the two fasteners holding the pulley
cover and remove cover (Fig. 420).
5. Using a 12" (30.5cm) crow foot pry bar, insert the
DSC-0777
end of the crow foot between the idler bracket tab
and the idler pivot shaft (Fig. 421).
DSC-0778
Rev. 000
Figure 420 DSC-0779
Figure 421 DSC-0785
TX 413 Service Manual