Toro Dingo TX 413 Service Manual page 123

HYDRAULIC LIFT ASSEMBLY
5. Route the auxiliary hose through the loader arm
assembly and connect it to the female quick
coupler fitting and tighten (Fig. 308).
Figure 308
6. Route the other auxiliary hydraulic hose, (the one
that is marked when removed), and connect it
to the male quick coupler fitting and tighten (Fig.
309).
Figure 309
7-34
7. Grease the pivot pin for ram end of the hydraulic
lift cylinder and install on the loader arm (Fig.
310).
DSC-1054
8. Align the hole for the bolt that retains the pivot pin
for the hydraulic lift cylinder. Install the bolt and
nut and tighten to 16 + 2 ft-lbs. (21.7 + 2.7 Nm)
(Fig. 311).
DSC-1053
9. Using a grease gun, apply grease to the grease
fitting for the pivot pin.
Rev. 000
Figure 310 DSC-1066
Figure 311 DSC-1043
TX 413 Service Manual