Hydraulic Lift Cylinder Installation - Toro Dingo TX 413 Service Manual

12. Remove the hydraulic lift cylinder from the frame
of the unit (Fig. 273).
Figure 273
13. Remove the three cable ties (Note the location
of the cable ties) from the hydraulic hoses and
remove the hoses from the lift cylinder (Fig. 274).
Figure 274
14. For information on repairing the Hydraulic Lift
Cylinder, refer to Hydraulic Lift Repair, page 7-40.
TX 413 Service Manual

Hydraulic Lift Cylinder Installation

Note: As a reminder, prior to connecting the
hydraulic lines, the O-rings and seals
should be replaced with new ones and
lightly lubricated with petroleum jelly.
1. Install the hydraulic hoses to the lift cylinder.
Replace the cable ties to the hydraulic hose and
hydraulic lift cylinder and tighten the hoses (Fig.
275).
DSC-1016
2. Route the two hydraulic hoses from the hydraulic
lift cylinder through the frame opening to the rear
of the barrel end of the lift cylinder (Fig. 276).
DSC-1018
A. Lift cylinder barrel
end
Rev. 000
HYDRAULIC LIFT ASSEMBLY
Figure 275
A
B
Figure 276
B. Pivot pin mounting
DSC-1018
DSC-1020
7-25