3. Use a large slotted screw driver to prevent the
trencher shaft from spinning and remove the bearing
locknut with a spanner wrench, p/n 999-9999 (Fig.
096 and Fig. 097).
TX 413 Service Manual
Fig 096
CLR DSC-0299
Fig 097
CLR DSC-0300
ATTACHMENTS
4. Remove the bearing lockwasher from the trencher
shaft (Fig. 098).
5. Remove the tongued washer from the trencher shaft
(Fig. 099).
Rev. 001
Fig 098
CLR DSC-0301
Fig 099
CLR DSC-0302
10-27