Toro Dingo TX 413 Service Manual page 217

ATTACHMENTS
14. Place a new o-ring on the hydraulic motor (Fig. 062).
15. Place the key in the groove of the hydraulic motor
shaft (Fig. 063).
10-18
Fig 062 CLR DSC-0194
Fig 063 CLR DSC-0198
16. Align the key of the hydraulic motor with the keyway
of the auger shaft. Lower the hydraulic motor into the
auger housing. Make sure the 90
face away from the traction unit (Fig. 064).
17. Install the four 3/8" hex head bolts into the hydraulic
motor and fasten to the auger housing. Torque to
25 ft-lbs. (34 Nm) (Fig. 065).
Note: Using an extension can reduce torque by one
or two pounds.
Rev. 001
o
hydraulic fittings
Fig 064 CLR DSC-0199
Fig 065 CLR DSC-0210
TX 413 Service Manual