Toro Dingo TX 413 Service Manual page 170

7. Using a wheel puller, remove the drive wheel
(Fig. 477).
Figure 477
8. Loosen the hydraulic line nuts located at the
hydrostatic pump (Fig. 478).
Figure 478
TX 413 Service Manual
9. Using an off-set open-end wrench, remove both
hydraulic line nuts from the fittings located on the
top of the wheel motor (Fig. 479).
DSC-0839
10. Remove both hydraulic fittings located at the top
of the wheel motor (Fig. 480).
NOTE: Remove the belt cover for easier access
to the right hand hydraulic fitting.
DSC-0845
Rev. 000
DRIVE SYSTEM
Figure 479 DSC-0842
Figure 480 DSC-0846
8-17