8. Pull the two hydraulic hoses from the rear of the
unit out the side, under the loader arm (Fig. 235).
Figure 235
9. Pull the two hydraulic hoses through the front
opening of the loader arm (Fig. 236).
Figure 236
TX 413 Service Manual
10. Remove the shoulder bolt that holds the pivot
pin on the ram end of the hydraulic cylinder (Fig.
237).
DSC-0975
11. Using a drift punch and a hammer, drive the pivot
pin out of the ram end of the hydraulic tilt cylinder
(Fig. 238).
DSC-0977
Rev. 000
HYDRAULIC LIFT ASSEMBLY
Figure 237
Figure 238
DSC-0979
DSC-0980
7-15